2-way powered studio monitor with 7″ woofer, AMT tweeter, CoP Technology, and DSP. Extend mode provides deeper low-frequency extension (at the cost of some SPL).
Adjust the volume and input sensitivity to optimize the speaker’s output and signal-to-noise ratio.
Analog and AES digital inputs facilitate system integration.
Audiofuse 16rig included Arturia AudioFuse Control Center software provides deep control of Main and Cue Mixers, MIDI management, Routing Matrix, and preset design
The entire interface can be controlled via MIDI, including mixer levels and routing management with a class-compliant controller
Routing Matrix is used for controlling any analog and digital destination across Monitor, Phones, ADAT, Main Mix, Cue Mix, and Auxiliary sends
The included USB-A to USB-C cable, USB-C to USB-C cable, PSU, registration card, and removable rack ears guarantee compatibility with nearly any rack or desktop arrangement
Format: 500 Series (Compatible with most 500 Series chassis)
Construction: Handcrafted in England by Neve engineers
Sound Character: Retains the original 2264A’s unique sonic characteristics with the same architecture, matching components, and original hand-wound transformers
Circuit Design: Diode-bridge limiter/compressor with high-headroom Class A/B design
True Neve 88RS mic preamp in a 500-series format, with transformer-coupled Mic input, electronically balanced Line and DI inputs and Line output
REGeneration feature allows Line and DI inputs to be fed through the Mic input transformer to inject the legendary Neve sound
Sweepable high pass filter can be switched in or out
Intelligent 48v phantom power function
-20dB pad and phase reversal features for Mic, Line & DI inputs
Signal Presence LED illuminates green from a level of -25dB and red from a level of +26dB Front combi-XLR connector for Mic input (XLR) and Line & DI inputs (1/4” TRS jack – LIFT switch eliminates potential ground loops when using unbalanced jack connectors in the front input
Compatible 500-series rack/enclosure with Power Supply and line-level input/output connectors required, not supplied.